1. Thoroughly wash with soap and water. Degrease the substrate with System 20 solvent or water borne degreaser. This removes any surface contaminants like grease, dirt and industrial fallout.
  2. Abrade the substrate with 180-320 grit.
  3. Any hard to reach areas should be abraded by hand with a red medium scuff pad.
  4. Once abraded, blow off with compressed air and thoroughly degrease with water based degreaser.
  5. Wipe the substrate with a tack rag.
  6. You are now ready to shoot RAPTOR.

Don’t miss out our TOP TIPS!